PEG-20M填充柱測定食品級二氧化碳，室內空氣，TVOC，環氧乙烷，三甲胺，粗苯，變壓器油，多氯聯苯，植物油，6號溶劑，脂肪酸，硫化物，羰基硫，二氧化硫，二硫化碳，雜醇油

填充柱測定食品級二氧化碳
填充柱測定食品級二氧化碳 詳細信息：

固定液：10%聚乙二醇

擔體：101白色擔體

粒度：0.17mm--0.25mm
規格：2M*3MM ,3m*3mm

型號：PEG-20M/101

應用：

GB 10621-2006 食品添加劑 液體二氧化碳
GB 1886.228-2016 食品安家標準 食品添加劑 二氧化碳

食品級二氧化碳質量的優劣與人們的身體健康密切相關,因此嚴格控制二氧化碳產品中的雜質顯得尤為重要。我國已出臺了控制食品級二氧化碳中雜質含量的標準,但該標準所涉及的級標準物質大部分均為空白,導致量值溯源和傳遞存在缺陷。同時,我國食品級二氧化碳來源廣泛,雜質含量和提純水平參差不齊,直接影響了后續食品質量。因此研制食品級二氧化碳中痕量組分的氣體標準物質,對嚴格把好我國食品添加劑二氧化碳質量關,統一檢測標準具有重要意義。具體研究成果如下： 1.采用重量法分別制備了C2H5OH／CO2、C6H6／CO2、H2S／CO2、SO2／CO2、COS／CO2、O2／CO2、C2H3Cl／CO2七種氣體標準物質。在制備過程中對乙醇、苯和硫化物分別進行了氣瓶吸附性的考察,結果顯示采用經過特殊處理的氣瓶和預飽和技術,氣瓶吸附性基本可以忽略。 2.通過優化氣相色譜測定條件,分別選出了七種雜質的分析方法,RSD均不超過1.3%,線性相關系數均大于0.9992。 3.對所研制的標準氣體進行了混勻考察、方法比對,并對前五種標物進行了復現性、量值隨時間變化、量值隨壓力變化進行了考察,結果良好。 4.對重量制備方法以及制備后半年量值的穩定性兩部分不確定度進行總體評定,前五種標物的相對擴展不確定度均在2%以內,達到了級標準物質申報要求,已被質檢總局批準為二級標準物質。

填充柱測定食品級二氧化碳 圖片：



Determination of food grade carbon dioxide by PEG-20M column
Determination of food grade carbon dioxide by PEG-20M column Detailed information:

Fixative: 10% polyethylene glycol

Support: 101 white carrier

Particle size: 0.17mm--0.25mm

Model: PEG-20M/101

application:

GB 10621-2006 food additive liquid carbon dioxide
GB 1886.228-2016 National Food Safety Standards Food Additives Carbon Dioxide





The quality of food-grade carbon dioxide is closely related to people's health, so it is especially important to strictly control the impurities in carbon dioxide products. China has introduced national standards for controlling the content of impurities in food grade carbon dioxide, but most of the national standard materials involved in the standard are blank, which leads to defects in traceability and transmission. At the same time, China's food-grade carbon dioxide sources are extensive, impurity levels and purification levels are uneven, directly affecting the quality of subsequent food. Therefore, the development of gas standard materials for trace components in food-grade carbon dioxide is of great significance for strictly controlling the quality of carbon dioxide in China's food additives and unifying national testing standards. The specific research results are as follows:1. Seven gas standard materials such as C2H5OH/CO2, C6H6/CO2, H2S/CO2, SO2/CO2, COS/CO2, O2/CO2, C2H3Cl/CO2 were prepared by gravimetric method. The adsorption of ethanol, benzene and sulfide were investigated in the preparation process. The results showed that the adsorption capacity of the cylinder was negligible with the specially treated gas cylinder and pre-saturation technology. By optimizing the gas chromatographic conditions, the best analytical methods for seven impurities were selected. The RSD was no more than 1.3%, and the linear correlation coefficient was greater than 0.9992. The standard gas was developed and compared, and the first five kinds of standards were reproducible, the quantity changed with time, and the quantity changed with pressure. The result was good. 4. The two parts of the uncertainty of the weight preparation method and the stability of the semi-annual value after preparation are evaluated. The relative expansion uncertainty of the first five standards is within 2%, which meets the national standard substance declaration requirements. It has been approved by the General Administration of Quality Supervision, Inspection and Quarantine as a national secondary standard substance.

Determination of food grade carbon dioxide by PEG-20M column